Dolomite DS 3202 GLOSSY White

Substrates: Steel furniture, steel frame, steel drum or other metal substrates.

Area of Use: Interiors and Exteriors.

Properties

Finish                                                      : Smooth/Glossy.

(Available in Glossy and Matt on request)

Color                                                       : All colors as per DOLOMITE shade card

Specific gravity                                        : 1.41+/-.005

Mixed Solids (% by volume)                   : 52 ± 2

Diluent                                                    : Xylene

Flash point                                              : 27°c

Spread Rate:

While the spread rate is directly dependent on the surface profile and also the type of undulations it has, as a thumb rule DOLOMITE Quick Drying Enamel would cover 10 – 12 meters per lit.

Drying Time (30° C)                                : Set to touch: 1.5 – 2 hours.

: Ready for Recoat: app 6 hours.

Recommended DFT                                 : 1 mist coat followed by a good full coat.

App 35 – 40 mic.

A good surface preparation and following the method statement / recommended system procedure of DOLOMITE is an ideal recommendation for the application of DOLOMITE Quick Drying Enamel.

For Metals & Steel Surfaces:

Achieve a good and clean surface by removing all contaminants by cleaning & drying. A laitance free surface should be achieved by good sweep blast or a wire brush. Apply one coat of DOLOMITE Quick Drying Primer and proceed after drying. Apply one good coat or two nominal coats with a spray or a suitable roller and obtain the desired coverage.

Exclusions for successful application include perpetually wet surfaces and also large cavities on wood, metal or concrete surfaces.

Adequate ventilation is an ideal situation as it helps in drying and the good application itself. Avoid high humid conditions i.e., >95% when condensation is likely to interfere and also when the surface temperature is at least 3°c above dew point.

Application: To be done by conventional roller or spray at 2000 – 2500 psi for airless spray or 50 – 60 psi for conventional spray). Nozzle size: 0.015 – 0.018 inches.

One can add 5 – 10% of DOLOMITE QD Thinner for ease of application of brush/roller/or spray viscosity.

Caution: Over diluting would result in sag and run downs.

Under dry and cool condition, Storage stability can be sound up to 18 months in original sealed containers.

HANDLING

Disposal: As per the guidance and legislations of the local Authority e.g., by controlled landfill. In case of doubt, consult local authority. Do not empty into drains, sewers or other water courses.

Flash Point: Contains aromatic hydrocarbons and 27°C.

Avoid contact with the skin and eyes. Wear suitable protective clothing such as overalls, goggles, dust mask and gloves. Use a barrier cream. Other industrial practices are applicable.

Ensure that there is adequate ventilation in the area where the product is being applied. Do not breathe vapor or spray.

MSDS is available on request for the safe handling of this product.

FIRST AID

Eyes: In the event of accidental splashes, flush eyes with warm water immediately and obtain medical advice.

Skin: Wash skin thoroughly with soap and water or approved Industrial cleaner. DO NOT USE solvent or thinners.

Inhalation: Remove to fresh air, loosen collar and keep patient rested.

Ingestion: In case of accidental ingestion DO NOT INDUCE VOMITING. Obtain immediate medical attention.